erledigt Milan GT MK6

Beiträge
71
I have a new Milan GT that was delivered to me at the beginning of August. I have tried every possible combination to get a good fit but without any luck. I put just under 400km on it trying different configurations, now it’s parked waiting for a new owner
I could start cutting but I really don’t want to go down that road.
If your interested you can find the details of the Milan on velomobileworld.com order number 514.
I paid over 10.000,00 Euro and would be willing to accept 9.500,00 Euro.
It has 140mm kranks, 11-32 cassette and 61-39 chain ring, standard hood.
The Milan is located in Herrieden near Ansbach.
 

Anhänge

  • A62E3B1B-C866-4BFF-BBD6-81539B3972CF.jpeg
    A62E3B1B-C866-4BFF-BBD6-81539B3972CF.jpeg
    135,4 KB · Aufrufe: 802
  • C042FD9B-7E65-4961-A9A2-6F509D387769.jpeg
    C042FD9B-7E65-4961-A9A2-6F509D387769.jpeg
    201,8 KB · Aufrufe: 806
The main reason for the poor fit is the floor bracing under and behind the seat and the metal bracket the seat leans against. I could only get the seat back about two cm, I need 5-10cm for a good fit.
 

Anhänge

  • 1CB57107-839E-4CD6-891D-0982AC3A7E6E.jpeg
    1CB57107-839E-4CD6-891D-0982AC3A7E6E.jpeg
    126 KB · Aufrufe: 314
  • A9EFA4EC-33C4-436C-A466-3A60096FF05E.jpeg
    A9EFA4EC-33C4-436C-A466-3A60096FF05E.jpeg
    90,2 KB · Aufrufe: 306
Well in my Milan, i just drilled some extra holes in the seat to move it further back.
 
I’m a tall guy at 200mm so getting a good fit in the Milan took some time and a few modifications. After speaking with Jan I removed part of the floor bracing and removed the rear seat support. I also had to trim some carbon from the neck area and remove the head padding. All in all it works perfectly now and I have been able to drive it with out issue. So now I have decided to keep the Milan and sell the quest. I will post the quest later in a separate add, but if anyone is interested the quest was purchased new in November 2019.
 
Zurück
Oben Unten